GE LOGIQ E10 Service Manual

DIRECTION 5750007-1EN, REV. 1 LOGIQ E10 BASIC SERVICE MANUAL
8 - 20 Section 8-4 - Loading / Reloading / Upgrading the Software
Verifying the Software Versions
1.) From the Touch Panel, select Utility -> System -> About.
2.) Verify software version matches the version in the software used during installation, version
received with Kit.
Verifying the TCP/IP settings
1.) From the Touch Panel, select Utility -> Connectivity -> TCP/IP.
2.) Verify TCP/IP settings.
3.) Select “Save settings.”
4.) Select OK to continue.
5.) Reboot system.
Verifying the AE Title and Port settings
1.) From the Touch Panel, select Utility -> Connectivity -> Device.
2.) Verify Device settings.
3.) Select “Save settings.”
4.) Select OK to continue.
Check Patient Archive
Confirm that the Patient Archive is available. If the patient archive is encrypted, you will need the
Encryption Key or password to unlock.
Functional Checks
Perform the following functional checks to confirm the system is operational before returning the system
to the customer.
Table 8-10 Loading C Partition Only Software Functional Checks
See:
Section
Functional Check Debrief Script
4-2-3 Power ON/Boot Up
LOGIQ E10 Basic Service Manual, Direction
5750007-1EN, Rev. 1. Equipment passed all
required checks and is ready for use.
4-2-7 Probe/Connectors Checks
4-2-7 B-Mode Checks
4-2-7 System CFM and PWD Checks
4-2-7 Basic Measurements
4-2-4 Power SHUT DOWN

GE LOGIQ E10 Specifications

General

Touchscreen	Yes
3D/4D Imaging	Yes
Applications	Vascular, Cardiac, Musculoskeletal, OB/GYN
Image Storage	USB, Network
Connectivity	DICOM, Ethernet, Wireless