DIRECTION 5750007-1EN, REV. 1 LOGIQ E10 BASIC SERVICE MANUAL
Chapter 8 Replacement Procedures 8 - 281
2.
Remove the GPU to ECB Cable from the
ECB and GPU.
Remove the two T10, GPU lower retainer
screws (circled) and remove the retainer.
Note how the retainer is assembled. Both
lower retainer halves are identical.
3.
Remove the rear, GPU upper retainer T10
mounting screw and loosen the front T10
screw. The upper retainer has slot for the
front T10 screw.
Slide the retainer away from the ECB.
Note how the retainer is removed, it must
be re-installed in the same manner.
Table 8-308 GPU removal
Steps Corresponding Graphic
To Next Page
Loading...
