DIRECTION 5750007-1EN, REV. 1 LOGIQ E10 BASIC SERVICE MANUAL
Chapter 8 Replacement Procedures 8 - 283
3.
Re-install the rear, GPU upper retainer T10
mounting screw.
4.
Locate the two T10, GPU lower retainer
mounting holes (circled).
5.
Assemble the GPU lower retainer, as
removed and re-install the two T10 screws.
Hand tighten.
Apply slight, even pressure on to the lower
retainer halves and tighten the screws
evenly.
Table 8-309 GPU installation
Steps Corresponding Graphic
To Next Page
Loading...
