DIRECTION 5750007-1EN, REV. 1 LOGIQ E10 BASIC SERVICE MANUAL
Chapter 8 Replacement Procedures 8 - 307
13.
Disconnect the Subwoofer audio cable
from J9 on the Backplane.
14.
Remove the four hex screwlocks (.312
inches long, on the right) and two locking
posts (on the left) attached to the
Connector Panel, using a 3/16 hex driver.
DO NOT discard the hex screwlocks or the
locking posts.
Table 8-329 Backplane removal
Steps Corresponding Graphic
To Next Page
Loading...
