GE LOGIQ E10 Service Manual

DIRECTION 5750007-1EN, REV. 1 LOGIQ E10 BASIC SERVICE MANUAL
8 - 360 Section 8-11 - Front End Acquisition / Card Cage parts replacement
ECG
LOGIQ E10 Basic Service Manual, Direction
5750007-1EN, Rev. 1. Leakage Current
measured at (record the value) and meets
allowable limits. Equipment passed all required
checks and is ready for use.
4-2-7 Probe/Connectors Checks
4-2-7
PW/CW Doppler Mode Checks
use pencil probes
10-7-7
Isolated patient lead (source) leakage-
lead to ground
10-7-8
Isolated patient lead (source) leakage–
lead to lead
10-7-9
Isolated patient lead (sink) leakage-
isolation test
4-2-7
ECG Checks
Active ECG:
Utility -> Applications ->
Settings -> ECG -> Show ECG Tools.
Connect cables. Press Display ECG Tab
on TP. Verify ECG signal displayed on
monitor.
Plug in the ECG cables with nothing
attached so they pick up noise.
Diagnostics
4-2-7
Shear Wave Elastography (Shear Elasto)
Functional Checks
Power Assistant
4-2-7 Probe/Connectors Checks
Verify Power Assistant Option functions
Table 8-370 Option Box replacement Functional Checks
See:
Section
Functional Check Debrief Script

GE LOGIQ E10 Specifications

General

Touchscreen	Yes
3D/4D Imaging	Yes
Applications	Vascular, Cardiac, Musculoskeletal, OB/GYN
Image Storage	USB, Network
Connectivity	DICOM, Ethernet, Wireless