GE LOGIQ E10 Service Manual

DIRECTION 5750007-1EN, REV. 1 LOGIQ E10 BASIC SERVICE MANUAL
3 - 2 Section 3-2 - Setup reminders
Section 3-2
Setup reminders
Contents in this section
3-2-1 Average setup time . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3-2
3-2-2 Setup warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3-2
3-2-1 Average setup time
3-2-2 Setup warnings
Table 3-1 Average setup time
DESCRIPTION
AVERAGE SETUP
TIME COMMENTS
UNPACKING THE LOGIQ E10 0.5 HOUR
SET UP LOGIQ E10 WO/OPTIONS 4 HOURS DEPENDENT ON THE CONFIGURATION
DICOM NETWORK CONFIGURATION 2 HOURS OR MORE DEPENDENT ON THE CONFIGURATION
INSTALL INSITE 0.5 HOUR
DANGER
WHEN USING ANY TEST INSTRUMENT THAT IS CAPABLE OF OPENING THE
AC GROUND LINE (FOR EXAMPLE, THE METER’S GROUND SWITCH IS OPEN),
DO NOT TOUCH THE LOGIQ E10!
CAUTION
TO PREVENT ELECTRICAL SHOCK, CONNECT THE LOGIQ E10 TO A PROPERLY GROUNDED
POWER OUTLET. DO NOT USE A THREE-TO-TWO PRONG ADAPTER. THIS DEFEATS SAFETY
GROUNDING.
CAUTION
DO NOT WEAR THE ESD WRIST STRAP WHEN YOU WORK ON LIVE CIRCUITS AND MORE
THAN 30 V PEAK IS PRESENT.
CAUTION
DO NOT OPERATE THE LOGIQ E10 UNLESS ALL BOARD COVERS AND FRAME PANELS ARE
SECURELY IN PLACE. LOGIQ E10 PERFORMANCE AND COOLING REQUIRE THIS.
NOTICE
NEVER REVERSE POLARITY ON ANY METER THAT INTERCEPTS THE POWER CORD WITH
POWER CONNECTED TO THE LOGIQ E10.
EVEN IN THE OFF STATE, REVERSING POLARITY ON THE POWER CAN SERIOUSLY DAMAGE
THE POWER SUPPLY.
CAUTION
IF THE LOGIQ E10 IS VERY HOT OR COLD, ALLOW THE TEMPERATURE TO STABILIZE
BEFORE POWERING UP. FOR GUIDELINES ON REACHING OPERATIONAL TEMPERATURES
FROM STORAGE OR TRANSPORT TEMPERATURES, SEE 2-2-1 "LOGIQ E10 environmental
requirements" on page 2-2

GE LOGIQ E10 Specifications

General

Touchscreen	Yes
3D/4D Imaging	Yes
Applications	Vascular, Cardiac, Musculoskeletal, OB/GYN
Image Storage	USB, Network
Connectivity	DICOM, Ethernet, Wireless