GE LOGIQ V1 - Using Scan Coach (for R1.0.X)

Performing an Exam
2-20 LOGIQ V2/LOGIQ V1 – User Guide
Direction 5610736-100
Rev. 9
Using Scan Coach (For R1.0.x)
1. Go to Utility -> Scan / Assistant -> Scan Assistant Manager,
select the protocol from the left column, and select >> to
move it to the Program Selections column. Then select
Exit to the Scanning page.
2. Press Patient key on the control panel to register a new
patient. Then select the protocol from the pull-down menu,
and then select Scan to navigate to the Scan Coach screen.
Figure 2-3. Scan Coach Start