System Start-Up
LOGIQ V2/LOGIQ V1 – User Guide 1-51
Direction 5610736-100 Rev. 9
Power Off
For optimum system operation, we recommend that you restart
the system at least once every 24-hour period. If you shut down
the system at the end of the day, no other action is needed.
To power off the system:
1. When you shutdown the system, enter the scan screen and
lightly press the Power On/Off switch at the front of the
system once. The System-Exit window is displayed.
NOTE: DO NOT press and hold down the Power On/Off switch to
shutdown the system. Instead, lightly press the Power On/
Off switch and select Shutdown.
2. Using the Trackball, select Shutdown.
The shutdown process takes a few seconds and is
completed when the Power On/Off switch illumination turns
from green to off.
NOTE: DO NOT select Exit for Shutdown. Exit is only available to
Service representative.
NOTE: If the system has not fully shut down in 60 seconds in the
power-off sequence, press and hold down the On/Off switch
until the system shuts down.
3. Disconnect the probes.
Clean or disinfect all probes as necessary. Store them in
their shipping cases or another appropriate probe storage
system to avoid damage.
4. Disconnect AC adapter mains plug from the power outlet.
NOTE: Disconnect the AC adapter mains plug from the outlet if the
system has been fully charged. Connect the AC adapter
mains plug to the outlet if the system needs to be charged
and then disconnect it when the system has been fully
charged.
To Next Page
Loading...
