System Care and Maintenance
LOGIQ V2/LOGIQ V1 – User Guide 3-39
Direction 5610736-100 Rev. 9
Cleaning the system
Prior to cleaning any part of the system:
1. Turn off the system power. Disconnect the power cord. See
‘Power Off’ on page 1-51 for more information.
2. Remove the battery.
System Cabinet
To clean the system cabinet:
1. Moisten a soft, non-abrasive folded cloth with a mild,
general purpose, non-abrasive soap and water solution.
NOTE: The cloth should be damp, not dripping wet.
2. Wipe down the top, front, back, and both sides of the system
cabinet. Be careful with the output and input ports of the
system and do not allow anything especially liquid enter into
the ports.
3. Wipe off excess cleaning agents.
NOTE: Do not spray any liquid directly into the unit.
LCD Monitor
To clean the monitor face:
Use a soft, folded cloth. Gently wipe the monitor face.
Do NOT use a glass cleaner that has a hydrocarbon base (such
as Benzene, Methyl Alcohol or Methyl Ethyl Ketone) on monitors
with the filter (anti-glare shield). Hard rubbing will also damage
the filter.
NOTE: When cleaning the screen, make sure not to scratch the
monitor.
Ensure that you follow the cleaning procedure and use the
cleaning agents provided in this manual.
To Next Page
Loading...
Need help?
General
