After the Exam is Over
3-18 LOGIQ V2/LOGIQ V1 – User Guide
Direction 5610736-100
Rev. 9
EZBackup and EZMove (continued)
NOTE: EZBackup/EZMove saves data as RAW data. If you import data
to the system, you can modify the image data.
NOTE: To display exported Raw DICOM images on a PC, you need the
dedicated viewer.
NOTE: When backing up or moving reports using EZBackup and
EZMove, use the USB HDD. DVDs and CDs are not supported
for backing up or moving reports using EZBackup and EZMove.
NOTE: “Archived” information is saved to each exam during EZBackup.
When you perform EZBackup, the system backs up the exams
except for the archived exam.
NOTE: EZBackup/EZMove cannot span a single image across two (2)
or more media. Therefore, if EZBackup/EZMove encounters an
image that is greater than the capacity of the media, it skips the
oversized image.
NOTE: EZBackup/EZMove does not store images to media in
sequential order. Instead it maximizes the most amount of
images per media.
NOTE: If the system locks up during the media auto format process,
shutdown the system by holding down the power button and
boot it up again. After the system is up, replace the media to a
new one and execute EZBackup or EZMove again. To avoid
data loss, do not reuse the failed media for any other function.
NOTE: If you try exporting a previously moved exam, the message
“Can’t Find Source file” displays. The image data had already
been removed from the hard disk drive with EZBackup/EZMove.
NEVER restore the patient archive from media made previous
to the last move.
To Next Page
Loading...
