Detach tray
The tray can be detached from the rocker platform in tilt position and in normal position.
Tilt position is recommended, as described in the instructions below.
ActionStep
Hold the textured grip area on each side of the tray and slide it upwards so
that the attachment pins on the tray disengage from the holes in the rocker
platform.
1
Pull the tray towards you.2
Note:
If the tray is detached with the rocker in normal position, you will need to lift
the tray by the upper edge before sliding it away from you.
108 ReadyToProcess WAVE 25 Operating Instructions 29009597 AD
5 Operation
5.1 Set up the system
5.1.2 Attach and detach tray
To Next Page
Loading...
Need help?
General
