Initiate e-license configuration
Follow the steps below to initiate the e-license configuration.
ActionStep
In the Configure e-License dialog:1
Click Copy to Clipboard to copy the displayed Ethernet address to the
Windows clipboard.
Note:
If the address is not displayed, or if there are multiple network cards in the
computer, follow the steps described in Computer Ethernet address, on
page 95 to find the correct address. Do not click Copy to Clipboard.
Note:
When activating additional licenses, always use the Ethernet address for
the network card on the computer where the license server software is in-
stalled. Do not use the Ethernet addresses on additional client computers.
96 ReadyToProcess WAVE 25 Operating Instructions 29009597 AD
4 Installation
4.3 Software installation
4.3.2 Configure an e-license
To Next Page
Loading...
