Gefen EXT-MFP - Page 128

page | 118
Commands
Command Description
Audio
#set_mute
MUTE/UNMUTE both analog and HDMI outputs
#get_mute
Get MUTE/UNMUTE status
#set_analog_vol
Set analog analog output volume
#get_analog_vol
Get analog analog output volume
#set_analog_out
Set analog output on or off
#get_analog_out
Get status of analog output
#set_analog_mode
Set analog analog output mode
#get_analog_mode
Get analog analog output mode
#set_audio_link
Set associated audio source for selected input
#get_audio_link
Get associated audio source for selected input
EDID
#set_edid
Set Bank/Output EDID To Input / Bank
#set_bank_name
Set The EDID Bank Name
#get_bank_name
Set The EDID Bank Name
Network
#set_ipmode
Set Ip Mode To DHCP Or Manual
#get_ipmode
Get Current IP Mode
#get_ipcong
Get Ip Conguration
#set_ipadd
Set Ip Address
#get_ipadd
Print The Ip Address To The Screen
#set_netmask
Set Subnet Address
#get_netmask
Print The Netmask Address To The Screen
#set_gateway
Set Gateway Address
#get_gateway
Print The Gateway Address To The Screen
#set_http_port
Set The HTTP Communication Port
#get_http_port
Print The HTTP Communication Port To The Screen
#set_telnet_enable
Enable Or Disable Telnet Access
#get_telnet_enable
Print The Telnet Access Status To The Screen
#set_telnet_port
Set The Telnet Communication Port
#get_telnet_port
Print The Telnet Communication Port To The Screen
#set_use_telnet_pass
Enable Or Disable The Telnet Password
#get_use_telnet_pass
Get Status Of Use Telnet Password
#set_telnet_welcome
Enable Or Disable The Telnet Welcome Screen
#get_telnet_welcome
Get Status Of The Telnet Welcome Screen
#set_udp_port
Set The UDP Communication Port
Advanced Operation Advanced Operation