Gefen EXT-MFP - Page 129

page | 119
Commands
Command Description
#get_udp_port
Get The UDP Communication Port
#set_remote_udp_enable
Enable Or Disable The Remote UDP Access
#get_remote_udp_enable
Get Status Of Remote UDP Access
#set_udp_remote_ip
Set The Remote UDP Ip Address
#get_udp_remote_ip
Get The Remote UDP Ip Address
#set_udp_remote_port
Set The Remote UDP Communication Port
#get_udp_remote_port
Get The Remote UDP Communication Port
#set_udp_enable
Enable Or Disable The UDP Access
#get_udp_enable
Get Status Of The UDP Access
#set_webui_ad_pass
Set The Web UI Administrator Password
#set_webui_op_pass
Set The Web UI Operator Password
Discovery
#set_discovery
Enable/Disable Discovery Service
#get_discovery
Get Status Of Discovery Service
#set_showme
Turn The Discovery 'Show Me' Feature On / Off
#set_discovery_mode
Set The Discovery Read/Write Mode
#get_discovery_mode
Get The Discovery Read/Write Mode
#set_device_descr
Set The Device Description
#get_device_desc
Get The Device Description
System
#set_osd_timeout
Set OSD Timeout
#get_osd_timeout
Get OSD Timeout
#set_display_notify
Set Display Notications
#get_display_notify
Get Display Notications
#set_feedback
Turn (Unsolicited) RS-232 Feedback On Or Off
#get_feedback
Get Status Of RS-232 Feedback On Or Off
#get_rmware_version
Get Firmware Version
#set_ir_channel
Set IR Command Channel
#get_ir_channel
Get IR Command Channel
#factory_reset
Reset To Factory Defaults
#reboot
Reboot The Unit
Advanced Operation