gefran SIEIDrive ADL300

144 ADL300 • Appendix
Lift control outputs can usually be connected to the PAD parameters according to the table below:
Bit Description Remarks
0 LiftEnable Lift enable command.
1 RunCont Run command contactor
2 UpCont Up command contactor
3 DownCont Down command contactor
4 BrakeCont Brake command contactor
5 LiftDcBrake DC brake function command (firmware)
6 Brake2 Brake control signal (See sequences)
7 DoorOpen Open door command
8 LiftStart Lift start command
9 -----
10
Lift status word Contains copy of the StatusWord (selectable via
SelLiftStatWord)
11 -----
12 -----
13 -----
14 InputVariable Connected to the input selector
15 LiftWdecInp Connected to the LifWDecomp selector
16
LiftStatusWord (connected to Pad11)
Bit Description Remarks
0 LiftEnable Lift enable command.
1 RunCont Run command contactor
2 UpCont Up command contactor
3 DownCont Down command contactor
4 BrakeCont Brake command contactor
5 LiftDcBrake DC brake function command (firmware)
6 Brake2 Brake control signal (See sequences)
7 DoorOpen Open door command
8 Drive Ok
9 SpeedIsZero
10 SpeedRefIsZero
11
12
13
14
15 (EPC Enable)
Outputs available directly on the drive:
- Drive OK
- SpeedIsZero
1.6.2 ADL300 Conguration
The example given in this section is based on the assumption that the parameters of the ADL300 drive are the factory set-
tings (Default parameter command). Use of the keypad is recommended for performing commissioning in the rst phase
(see the ADL300 “Quick start guide”). Then the motor should be moved using the digital input commands.
Similarly, a system start-up wizard must be available on the GF_Express congurator .
The programming sequence is as follows:
- Fieldbus conguration
- Fieldbus M2S conguration
- LIFT\LIFT IN/OUT conguration
- Fieldbus S2M conguration