ADL300 • Appendix 147
1.6.2.3 LIFT IN/OUT conguration
At this point, simply connect the individual Lift Decomp bits. Programming from the digital input to LIFT DECOMP LIFT/
INPUTS/OUTPUTS bit as shown in the gure below:
Now all lift sequences are controlled via the LiftWdecomp bits in the same way as described in the manual using digital
inputs.
Parameter 12102 Command input mon, displays state of word in Hex.
After running a save command and switching the drive on again, you can check the correct conguration of channels M →
S as shown in the gure:
To Next Page
Loading...
