gefran TPD32-EV-500 series - Acknowledging a Failure Alarm; Acknowledging When Several Failure Alarms Occur at the same Time; Motor Potentiometer Function; Acceleration, Deceleration

—————— TPD32-EV ——————
114
Acknowledging a failure alarm
External fault
XXXXXXXXXX
( MENU )
XXXXXXXXXX
CANC
- Ifafailureoccurs,theappropriatefailurealarmwillappearinthedisplayandthemessagewillash.
- AcknowledgeorresetthefailurebypressingtheCANCkey.Theconvertermustbedisabledforthisanda
Startcommandmustnotbepresent.
Acknowledging when several failure alarms occur at the same time
External fault
Multi failures
SPEC FUNCTIONS
Failure reset
E
- Whenseveralfailurealarmsoccuratthesametime,theblinkingmessage“Multifailures”willappearinthe
display.
- SelecttheparameterFailure resetintheSPECFUNCTIONSmenu.
- PresstheEkeytoacknowledgeorresetthefailurealarm.Theconvertermustbedisabledforthisandthere
shouldbenoStartcommandpresent.
5.1.5.3 Motor potentiometer function
note!  Tousethemotorpotentiometerfunction,thismustbeenabledwiththeEnable motor pot
parameterbyselectingconguration"Cong1"or"Cong2".Thefollowinginformation
referstoconguration"Cong1".
Acceleration, Deceleration
Motor pot
Motor pot oper
Accelerate
Decelerate
Motor pot oper
985 [rpm]
E
+
-
CANC
- SelecttheMotorpotoperparameterinthe“Motorpot”submenu.
- PressingEthecurrentreferencevalueisdisplayed.
- Pressthe+keytoincreasethereferencevalueandacceleratethedrive.
- Pressthe-keytodecreasethereferencevalueanddeceleratethedrive.Thisappliestobothrotationdirec-
tions.
- PressCANCtoreturntothe“Motorpot”submenu.