gefran TPD32-EV-500 series - Dimension Factor, Face Value Fator

—————— TPD32-EV ——————
194
6.11.7 Dimension factor, Face value fator
CONFIGURATION
Dimension fact
[50] Dimfactornum
[51] Dimfactorden
[52] Dimfactortext
Face value fact
[54] Facevaluenum
[53] Facevalueden
Thefactorfunctionconsistsoftwofactors-thedimensionfactorandthefacevaluefactor.Bothfactorsarede-
nedasfractions.Thedimensionfactorisusedtospecifythedrivespeedinadimensionrelatedtothemachine
concerned,e.g.kg/horm/min.Thefacevaluefactorisusedtoincreasetheresolution.
Seethecalculationexamplesgivenbeow.
Parameter description No.
Value
Standard
Conguration
min max
Factory
American
Factory
Standard
Dim factor num
50 1 65535 1 1
-
Dim factor den
51 1 +231-1 1 1
-
Dim factor text
52 rpm rpm
-
Face value num
54 1 +32767 1 1
-
Face value den
53 1 +32767 1 1
-
Dim factor num Numeratorofthedimensionfactor
Dim factor den Denominatorofthedimensionfactor
Dim factor text Unitofthedimensionfactor(5characters).Thistextisshowninthekeypaddisplay
forreferencevalueentry.Possiblecharacters:/%&+,-.0...9:<=>?A...Z[]a...z
Face value num Numeratorofthefacevaluefactor
Face value den Denominatorofthefacevaluefactor
Thereferencevaluegivenmultipliedwiththedimensionfactorandthefacevaluefactordenesthemotorspeedinrpm
Dimension factor
User
defined variable
X
Face value factor
X
Control variable
Dim factor num
1
Dim factor den
1
Dim factor text
rpm
Face value num
1
Face value den
1
Figure 6.11.7.1: Calculation using dimension and face value factors