gefran TPD32-EV-500 series - Function Description; Functions and Parameters

—————— TPD32-EV ——————
136
6 - FUNCTION DESCRIPTION
Functions and parameters
TheconvertersoftheTPD32-EVseriesfeatureanumberoffunctionsthatcanbesetandassignedparameters
inordertomeettherequirementsoftheapplicationathand.
Thedevicecanbecontrolledindifferentways:
- viatheterminalstrip
- viathekeypad
- viatheRS485serialinterface
- viaabusconnection(option)
ThesettingsrequiredaremadeviatheMain commandsandControl mode parametersintheCONFIGU-
RATIONmenu.
ThedeviceissuppliedwithaWindows
TM
-baseduserinterfacesoftwareforcontrollingthedriveandsetting
parametersviatheRS485serialinterface.
Thedeviceisfactorysetforspeedregulationwithacascadecurrentregulationandisconnectedaccordingtothe
connectiondiagramshownoninsection4.8,“Standardconnectiondiagrams”.Onlytheentryofparametersin
theSTARTUPofthesoftwareisrequiredfortheinitialcommissioningofthedrive.Thedriveisthuscontrolled
viatheterminalstripwithallparameterssetviathekeypad.
Iffunctionsarerequiredthatarenotinthestandardconguration,thesecanbeselectedandtheirparametersset
accordinglyviatheappropriatemenu.
TheTBOoptioncardisrequiredforexpandingthestandarddevicewithprogrammableinputs/outputs.Upto
no.2TBOscanbetted,eachproviding4digitalinputs,4digitaloutputsand2analogoutputs.Threeanalog
inputsareprovidedonthestandarddevice.
TheconvertersoftheTPD32-EVseriesenablereferencevaluesfortherampandforthespeedregulatortobe
setindifferentunitsofmeasure:
- inpercentagesoftheSpeed base value
- inaunitofmeasure(dimension)thattheusercandeneusingthefactorfunction,e.g.asspeedinm/s.
Accordingtowhichoneissetaslasttheotherwillbeupdated.Thismeansthattheotherreferencevalueis
overwrittenwiththecurrentvalue.
Afreelyselectablepassword1preventstheoperationoftheconverterbyunauthorizedpersons.Itisenteredin
theformofave-digitnumbercombination.Password2isalsoprovidedbythemanufacturer.Thispassword
enablestheservicepersonneltoaccesstheServicemenuwhichisnotaccessiblefortheuser.
note! Allparametersettingsmustbesavedotherwisethelastsettingssavedwillbeloadedthenext
timethedeviceisswitchedon(Saveparameterscommand)