gefran TPD32-EV-500 series - Page 363

—————— Instruction manual ——————
363
values(seeFigure6.4.2.1).IftheSpeedmaxamountischanged,theSpeed max pos
andSpeed max negparametersaresettothesamevalue.Ifoneofthesetwoparam-
etersischangedlater,thelastchangeisvalid.Thecurrentvalueforpositiverotation
(clockwise)isshowninthedisplayofthekeypad.Thevaluetobeenteredisbasedon
thefactorfunction.
Speed min pos Denestheminimumspeedfortheclockwiserotationofthemotor.Alowervaluethan
thedenedvalueisnotpossible,regardlessofthereferencevalue.Thefunctionhasan
effectontheinputoftheramp(seeFigure6.4.1.1).Thevaluetobeenteredisbasedon
thefactorfunction.
Speed max pos Denesthemaximumspeedfortheclockwiserotationofthemotor.Thefunctionhas
aneffectontheinputofthespeedregulator,andthereforetakesintoconsiderationthe
referencevaluethatcomesfromtherampaswellasthosethatareentereddirectly(see
Figure6.4.2.1).Thevaluetobeenteredisbasedonthefactorfunction.
Speed min neg Denestheminimumspeedfortheanti-clockwiserotationofthemotor(withTPD32-
EV...4B...).Alowervaluethanthedenedvalueisnotpossible,regardlessoftherefer-
encevalue.Thefunctionhasaneffectontheinputoftheramp(seeFigure6.4.1.1).The
valuetobeenteredisbasedonthefactorfunction.
Speed max neg Denesthemaximumspeedfortheanti-clockwiserotationofthemotor(withTPD32-
EV...4B...).Thefunctionhasaneffectontheinputofthespeedregulator,andtherefore
takesintoconsiderationthereferencevaluethatcomesfromtherampaswellasthe
thosethatareentereddirectly(seeFigure6.4.2.1).Thevaluetobeenteredisbasedon
thefactorfunction.