GRAPHTEC CE7000-60 - Page 119

CE7000-UM-251-9370 7-45
7 DISASSEMBLY AND REASSEMBLY
(10) Remove the M3L6 binding head screws holding the bearing covers and detach the bearing covers from
the pillow blocks. (Don’t loosen the M3L6 binding head screws holding the pillow blocks.)
CE7000-160
CE7000-130/130AP
Drive roller shaft
M3L6 binding head screw
Pillow block
Bearing cover
(11) Slide out the X-drive roller shaft to the left side and detach the X drive roller shaft from the unit.
When the X drive roller shaft is detaching, take care for the right side bush (collar), it will drop out.
How to reinstall the drive roller shaft
(1) Reattach in the reverse order in which it was detached.
(2) When the drive roller shaft is installing, conrm the position of bush as shown in the picture below.
Bush
Bearing
CE7000-160
CE7000-130/130AP
Drive roller shaft