CE7000-UM-251-9370 7-46
7 DISASSEMBLY AND REASSEMBLY
(3) When the X drive pulley is installing to the drive roller shaft, tighten the four M3L4 set screws while
pushing the drive pulley and the drive roller shaft to the following direction.
Drive roller shaft
X drive pulley
(4) Spread a suitable quantity of Loctite 222 on the four M3L4WP set screws holding the X-drive pulley.
(5) Perform the X-drive belt tension adjustment (Refer to subsection 7.3.3.).
(6) Reattach the other parts in the reverse order in which they were detached.
To Next Page
Loading...
