GRAPHTEC CE7000-60 - Page 179

CE7000-UM-251-9370 8-36
8 Electrical Adjustment
(7) Press the Right position key to display the adjustment menu shown below.
(8) Press the Up position key to display the following menu.
(9) Press the F2 key to display the following menu.
(10) Press the F1 key (MANUAL) to display the following menu.
(11) Press the F2 key (SCAN) to display the following menu.
(12) Move the tool position to the lower right area of cross mark target using the position keys, as shown in
the picture below.
Move the tool position to this area.