CE7000-UM-251-9370 8-37
8 Electrical Adjustment
(13) Press the ENTER key after the tool position was moved to the above area.
The plotter will scan the cross mark target, and then it will cut the cross mark target.
When the offset is correct, it will cut
onto the cross mark target.
When the offset is not correct, it will
cut near of the cross mark target.
Measure this distance for the X
offset adjustment.
Measure this distance for the X
offset adjustment.
Media Feeding direction
+Y
+X
-Y
-X
(14) When the offset is not correct measure the distance between the cross target line and the offset cutting
lines.
(15) The following menu is displayed after offset line cutting.
(16) Press the F2 key to input the X-offset adjustment value from the measured distance.
UP and down allow keys changes value
(17) Press the ENTER key, after it is input.
(18) Press the F3 key to input the Y-offset adjustment value from the measured distance.
UP and down allow keys changes value
To Next Page
Loading...
