GRAPHTEC CE7000-60 - Page 231

CE7000-UM-251-9370 28
9 TROUBLESHOOTING
Error
code
Error Display Cause Verication item Solution
E05009
The barcode can not
detect.
Conrm the printing
of barcode.
Conrm the printing of
barcode.
Move the tool position to
the barcode start mark
position correctly.
E05010
The rotation can not
set to the barcode
operation.
Conrm the rotation
is not set to ON.
Set the rotation setting
to OFF.
E05011
The reverse can not
set to the barcode
operation.
Conrm the reverse
is not set to ON.
Set the reverse setting
to OFF.
E05012
It can not nd
the data which is
specied with the
barcode.
Conrm the correct
data is saved to the
PC or USB memory.
Save the correct data
to the PC or the USB
memory.
E05013
It can not detect the
start mark for the
barcode.
Conrm the start
mark of barcode is
printing in the cutting
area.
Conrm when the media
is loading the start
barcode is not outside
of cutting area.
E05014
The USB memory
is not connected
to the plotter or the
Link server PC is
not connected to the
potter.
Conrm the target
device setting.
Connect the USB
memory or connect the
Link server PC to the
plotter.
E05015
The specied data
was not found in the
USB memory or the
Link server PC.
Conrm the specied
data is saved in the
USB memory or the
Link server PC.
Save the specied data
to the USB memory or
the Link server PC.
E05016
It could not connect
to the target device.
Conrm the USB
memory or the
Link server PC
is connecting the
plotter.
Connect the USB
memory or the Link
server PC to the plotter.
E05017
The media set lever
is lowered.
When the media set
lever is lowered while
link data is cutting,
the cutting job is
canceled.
Do not lower the set
lever if you do not want
to cancel the job.