4-11
It will copy in following order when COORDINATE AXES ROTATION is set.
Origin point
First cut
Copy origin point
Fifth copy
First copy
Copy space
Copy
space
Sixth copy
Third copy
Fourth copy
Second copy
Operation
1
Plot (cut) the data you want to copy once.
Cutting data is stored in the buffer memory.
2
Press the POSITION (
) keys and move the tool
carriage to the position to copy.
Supplement
•
When setting the copy interval, set "MEDIA
CHANGE MODE" to OFF.
•
NO DATA FOR COPY IN BUFFER!" is
displayed if there is no data in the buffer
memory. Send the cutting data.
•
If too much data is sent from the buffer
memory, "1 copy in the Copy mode buffer!"
will be displayed.
•
If the data to be copied is larger than the
cutting area, "Cannot copy, the valid area is
too small" will be displayed.
3
Press the [COPY] key
COPY MODE screen is displayed.
4
Press the [1] key (MEDIA CHANGE MODE).
MEDIA CHANGE MODE screen is displayed.
5
Press the [1] key (OFF).
Confirm the settings and it will return to the COPY MODE screen.
To Next Page
Loading...
