GRAPHTEC CE7000 Series - Change the Cutting Condition (Condition No.); Reset (Revert to the Initial State When the Power was Turned On.)

3-6
Change the cutting condition (Condition No.)
Go through the following steps to change the Cutting Condition (Condition No.):
Operation
1
Press the [ENTER] key in READY status.
CONDITION No. selection screen is displayed.
Supplement
It will return to state when the power is turned
on when the [ORIGIN] key (RESET) is pressed.
Please refer to for Reset (Revert to the initial
state when the power was turned on.).
2
Press the [1] key (No.1), the [2] key (No.2), the [3] key (No.3),
the [4] key (No.4), the [ ] key (No.5), the [ ] key (No.6), the
[ ] key (No.7), or the [ ] key (No.8), while simultaneously
pressing the [ENTER] key.
Setting will be conrmed and it will return to default screen.
Reset (Revert to the initial state when the power was turned on.)
To revert to the initial state when the power was turned on, do following:
Operation
1
Press the [ENTER] key in READY status.
CONDITION No. selection screen is displayed.
2
Press the [ORIGIN] key (RESET), while simultaneously
pressing the [ENTER] key.
Initialization is performed, and MEDIA SETTING screen is displayed.