GRAPHTEC CE7000 Series - Confirm the Results of the Cutting Test; Adjustment of Offset; Adjustment for Half Cutting; Adjustment for Cutting out

2-59
Conrm the results of the cutting test
Conrm the cutting test results, and adjust to optimal setting. Repeat cutting test and adjustment until optimal cut
is achieved.
Adjustment of Offset
Supplement
How to check offset
Check if the offset value is set correctly by
following.
Not enough adjustment
Increase the offset value.
Optimal offset value.
Too much adjustment.
Decrease the offset value.
Check the corners of the triangles and rectangles. See "Setting the
Tool Condition" and adjust the offset value if the corner is not cut or
if it is cut too much.
Adjust the offset value.
Adjustment for Half Cutting
Supplement
See "Adjusting the Blade Length" and "Setting
the Force" and adjust the settings.
Peel off the triangle area, and adjust so it cuts slightly into the
backing sheet.
If the backing sheet has been cut through, either the FORCE setting
is too high or the cutter-blade tip is extended too far. If the backing
sheet shows only a few traces of the cutter blade, either the FORCE
setting is too low or the cutter blade tip is not sufciently extended.
Adjustment for cutting out
Adjust so the media is completely cut out.
If the media is not completely cut, either the FORCE setting is too low or the cutter blade tip is not sufciently
extended.
See "Adjusting the Blade Length" and "Setting the Force" and adjust the settings.
Adjustment when using plotting pen
Adjust the FORCE so there will be no faint lines. To prolong the pen life, set the FORCE to the lowest setting
without any faint lines. See"Setting the Force" or setting the FORCE.