GRAPHTEC CE7000 Series - Setting Step Movement Distance

3-4
Setting step movement distance
The parameters when setting the cutting direction are determined by the distance of the cutting direction.
Operation
Supplement
Perform the settings in Normal mode.
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the POSITION ( ) key (ADV).
ADVANCE screen (1/4) is displayed.
3
Press the [1] key (MOVE STEP).
MOVE STEP screen is displayed.
Supplement
Value chosen here will be the movement
distance for the step movement.
4
Press the [1] key (1.0mm) or the [2] key (0.1mm).
Supplement
It will return to ADVANCE screen (1/4) without
changing the settings when you press the [ESC]
key (CANCEL).
5
Conrm the setting and press the [ENTER] key (SET).
Setting will be conrmed and it will return to ADVANCE screen (1/4)
screen (1/4).
6
Press the [PAUSE/MENU] key.
It will return to default screen.