2-42
Setting the tool condition
This section describes how to make the tool, speed, force and acceleration settings. Before cutting media, the
following four cutter-pen conditions must be specied.
• FORCE
• SPEED
• ACCELERATION
• OFFSET
CAUTION
•
It may result to damaging the cutter blade or the cutting mat if the blade is extended too much. Make sure the blade length is set
less than the thickness of the media.
Tool Conditions (Cutter Blade) for Each Media Type
See the Cutter Blade Manual.
Blade Part Nos., Displayed Blade Types, and CUTTER OFFSET Values
See the Cutter Blade Manual.
To Next Page
Loading...
