4-7
Setting mirror
There is a function to mirror the cutting by reversing the origin point and coordinate axes.
Set the MIRROR setting to ON to do mirroring.
Reference
This setting will be saved even if the power is shut off.
MIRROR mode OFF
MIRROR mode ON
Operation
Supplement
Perform the settings in Normal mode.
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the [3] key (AREA).
AREA PARAMETERS screen (1/2) is displayed.
3
Press the [3] key (MIRROR).
MIRROR screen is displayed.
To Next Page
Loading...
