GRAPHTEC CE7000 Series - Setting the Speed and Force (Simple Mode)

2-44
Setting the Speed and Force (Simple mode)
In Simple mode, set the speed and force to be used with each tool condition.
Setting range (SPEED) : 5 to 60 (in 5cm/s increment)
Setting range (FORCE) : Standard Value + Adjusted Value
The value of (reference value + adjustment value) is 1 to 38.
Operation
Supplement
•
Use Normal mode for changing the type of
blade, offset, and acceleration.
•
It will return to CONDITION screen without
changing the settings when you press the [4]
key (CANCEL) .
1
Press the [COND/TEST] key in the default screen.
CONDITION setting screen (1/5) is displayed.
2
Press the POSITION ( ) key and select the setting.
Select the preset Media Type (Tool Conditions).
3
Press the [2] key (SPEED) to change the speed.
The screen below will appear.
Supplement
•
Press the [ENTER] key (SET), conrm the
settings, and then return to the READY
screen.
•
Press the [4] key (RETURN) to return to the
READY screen without changing any settings.
4
Press the POSITION ( ) key and increase or decrease the
current value.
You can enter any value between 5 and 60 (in increments of
5cm/s).
If you only want to change the speed, press the [ENTER] key
(SET). Setting will be set, and it will return to default screen.
Setting will be set, and it will return to default screen.
5
When you want to change the force, press the [3] key
(FORCE).
The screen below will appear.