13 -11
Graphtec Studio
Step 1: Create registration mark (alignment mark) data.
When printing and cutting, it is necessary to attach registration marks (alignment marks) in order to know exactly
the printing position.
Margin is necessary around the registration marks.
When printing on sheet media, the following margins are required.
Leading edge Trailing edge
Right and left
edges
MARK TYPE 1 15mm or more 35mm or more 15mm or more
MARK TYPE 2 17mm or more 37mm or more 15mm or more
When printing on roll media, it is necessary to provide a margin of 6
mm or more between the registration mark of the rst sheet and the
registration mark of the second sheet. In addition, margins of 15 mm
or more must be provided at the left and right edges.
* The printing position may be different depending on the printer you
want to use, therefor It's recommended to take a margin as long as
several mm.
Feed direction of media
Margin
Operation
1-
1 Open the "Registration Marks" tab.
Specify the pattern, length, thickness, reference position of
registration mark.
Registration marks are created on the design screen.
Feed direction of media
Feed direction of media
MARK TYPE 1 MARK TYPE 2
To Next Page
Loading...
