GRAPHTEC CE7000 Series - 8.2 Automatic Pre Feed on Data Receipt

8-4
8.2
Perform Automatic Pre Feed When Cut Data
is Received
It is possible to feed and reverse the media automatically for specied amount when the plotter receives the
cutting data.
"Pre feeding" to prevent the shifting of media can be done automatically. Also, the media will be unrolled from the
roll before cutting when rolled media is to be used.
•
"Pre Feed of Media (Paper or Marking Film)"
•
"Perform Automatic Pre Feed When Media is Set (Initial Feed)"
Supplement
•
The setting for AUTO PRE FEED when cutting data is received is maintained even if the power is turned off.
•
Setting of the AUTO PRE FEED length is not linked to the setting of the page length. Change the setting for the page length if the
cutting area is to be long.
•
If data is received and auto media transfer is performed once, even if (cut in the same area) data is received again, auto media
transfer will not take place.
Operation
Supplement
Perform the settings in Normal mode.
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the [4] key (MEDIA).
MEDIA SETTING screen (1/2) is displayed.
3
Press the [2] key (AUTO PRE FEED).
AUTO PRE FEED screen is displayed.