14-3
14.2
Replacing Cutter Blade
Replace the cutter blade by referring to the structure diagram of the cutter pen.
CAUTION
To avoid bodily injury, handle cutter blades with care.
PHP33-CB09N-HS/
PHP33-CB15N-HS
Cutter blade
φ 0.9mm / φ1.5mm
Plunger
Plunger-cap
(Blue)/(Red)
Blade-length adjustment knob
Hole
Operation
1
Turn the blade-length adjustment knob in the direction of the
B arrow and pull the blade into the plunger.
One scale unit
approximately 0.1 mm
Scale
Scale
PHP33-CB09N-HS/PHP33-CB15N-HS
2
Turn the plunger cap in the counter-clockwise direction to
remove it from the plunger.
3
Remove the blade from inside the plunger cap.
4
Take a new blade out of its pack. Insert the new blade into
the hole provided in the plunger cap.
5
Insert the blade into the plunger cap and attach the plunger
from above in that state.
To Next Page
Loading...
