GRAPHTEC CE7000 Series - Carrier Sheet (for Affixing Media for Cutting)

2-21
Carrier Sheet (for Afxing Media for Cutting)
Using the carrier sheet (CR09300-A3) enables designs to be cut out of the following media types:
•
Media without an adhesive liner (peel-off backing sheet)
•
Media without a backing sheet
•
Media that is smaller than A3 size
•
Only CE7000-40/60 suppors it.
Usage Precautions
•
Be sure to use the carrier sheet when cutting around a printed design on the medium to create a cutout.
•
The carrier sheet is a reusable adhesive sheet that can be used repeatedly. However, if the carrier sheet
become warped or loses its adhesive strength, it can no longer be used. In such cases, please replace it with
a new carrier sheet. As a guideline, replace the carrier sheet after cutting 10 sheets. The cutting quality when
the same carrier sheet is used for cutting more than 10 sheets is not guaranteed.
•
When afxing a medium to the carrier sheet, be sure to press down on it rmly to ensure that it does not oat
up or peel away from the carrier sheet.
•
Make sure that media afxed to the carrier sheet has very little curl. A strongly-curled medium may cause
registration mark reading errors to occur, and it may get caught up in the pen carriage.
•
Afx only Graphtec-specied media to the carrier sheet. If using commercially-available inkjet media, please
note that media that is coated on both sides cannot be used. If the media is coated on one side only, afx the
non-coated side to the carrier sheet. If the coated side is afxed, the carrier sheet’s adhesive strength will be
weakened and may make the carrier sheet unusable.
•
If very smooth paper (paper that does not feel rough to the touch) is afxed to the carrier sheet, it will tend to
curl up when removed from the carrier sheet. Do not use such media.
•
When removing a medium from the carrier sheet after cutting it, be sure to remove it slowly and carefully.
•
The adhesive surface of the carrier sheet absorbs moisture easily. To prevent this occurring, do not remove
the carrier sheet from its package until just before use.
•
After use, reattach the separator that was removed from the adhesive surface prior to use, and then return the
carrier sheet to its package for storage.
•
For optimum storage, avoid locations where there is high humidity or where the package will be exposed to
direct sunlight.
•
There may be cases in which thin materials such as copy paper can no longer be peeled or torn.