GRAPHTEC CE7000 Series - Fan Suction Setting (FAN POWER)

10-7
Related to plotter environment
Fan suction setting (FAN POWER)
This function sets the suction force used to afx media to the plotter.
It may not feed properly if the media is thin, so set to "WEAK".
Operation
Supplement
Perform the settings in Normal mode.
1
Press the [PAUSE/MENU] key in the default screen.
MENU screen is displayed.
2
Press the POSITION ( ) key (ADV.).
ADVANCE screen (1/4) is displayed.
3
Press the POSITION ( ) key.
ADVANCE screen (4/4) is displayed.
4
Press the [4] key (FAN POWER).
FAN POWER screen is displayed.
5
Press the [1] key (NORMAL) or the [2] key (WEAK).
Supplement
It will return to ADVANCE screen (4/4) without
changing the settings when you press the [ESC]
key (CANCEL).
6
Conrm the setting and press the [ENTER] key (SET).
Setting will be conrmed and it will return to ADVANCE screen (4/4).
7
Press the [PAUSE/MENU] key.
It will return to default screen.