2-35
Normal mode
Menu screen
(Normal mode)
Contents of the operation and settings that is displayed in MENU screen with [PAUSE/MENU] key are as
following:
[1] (TOOL) : Set the setting for the operation of the tool.
[2] (ARMS) : Perform settings and operations related to alignment of tool and media, such as automatic
registration mark scanning by ARMS.
[3] (AREA) : Set the settings for area, scale, rotation, reverse, etc., of the cutting.
[4] (MEDIA) : Set the setting of the condition for the media.
[ ] (I/F) : Set the settings of the condition for the interfacing with the computer.
[ ] (ADV.) : Set the conditions for the basic operation of the cutting plotter, such as display language,
unit of the measurements and sensor.
[
] (TEST) : Does the operation necessary for maintenance, such as self diagnostic test or printout of
the condition settings list.
[ ] (LINK) : Performs operations necessary for output such as data link.
[PAUSE/MENU] : MENU screen will be closed and return to default screen.
[SLOW] : Displays the position key screen. When media is set, the tool point can be moved
See the "Menu Tree" in the Appendix A.4 for list of the descriptions about each settings.
To Next Page
Loading...
