4-2
4 .1
Settings for Cutting
Settings such as area and width of cutting, page length, mirrored, enlarged, shrunk, etc., can be set.
Setting cutting area
Supplement
•
See "Setting the Origin Point" about the
moving the origin point.
•
See "Setting Origin Point When HP-GL is
Set" for setting the origin point with HPGL
command.
Origin point will be set at lower left of the AREA once the AREA is
set. It is possible to set the origin point at the center when the HP-
GL is selected.
Move the origin point to change the cutting position.
Upper right set
position
Image already cut
Origin
point
It will only cut within
this range
Operation
Supplement
Perform the settings in Normal mode.
1
Press the [PAUSE/MENU] key in READY status.
MENU screen is displayed.
2
Press the [3] key (AREA).
AREA PARAMETERS screen (1/2) is displayed.
To Next Page
Loading...
