GRAPHTEC CE7000 Series - Setting the Cutting Direction

3-10
3.4
Setting the Cutting Direction
Rotate the coordinate axes to change the cutting direction.
Reference
The rotation settings will be saved even if the power is shut off.
Coordinate axes rotation
settings ON
Coordinate axes rotation
settings OFF
Operation
Supplement
Perform the settings in Normal mode.
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the [3] key (AREA).
AREA PARAMETERS screen (1/2) is displayed.
3
Press the [2] key (ROTATE).
ROTATE screen is displayed.