GRAPHTEC CE7000 Series - 8.5 Moving Speed Settings

8-9
8.5
Setting the MOVING SPEED
MOVING SPEED is the speed the tool moves when it is raised (tool up state).
The cutting time in total becomes short if you set the MOVING SPEED to fast speed even though the speed of the
tool when it is cutting (lowered) is set to slow speed for the hard to cut media (hard or sticky).
Supplement
This setting will be saved even if the power is shut off.
Operation
Supplement
Perform the settings in Normal mode.
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the [1] key (TOOL).
TOOLS SETTING screen (1/4) is displayed.
3
Press the POSITION ( ) key twice.
TOOLS SETTING screen (3/4) is displayed.
4
Press the [2] key (MOVING SPEED).
MOVING SPEED screen is displayed.