GRAPHTEC CE7000 Series - Table of Contents

C-1
CONTENTS
Preface ..............................................................I
Notes on this Manual ...........................................................I
Registered Trademarks .........................................................I
Copyright ....................................................................I
About the words and phrases in this text ................................. II
Prior to use ......................................................... II
Special Precautions on Handling Blades .................................III
Cutter Blades ................................................................III
Cutter plungers ..............................................................III
After Mounting the Cutter Plungers ...............................................III
After Turning on the Plotter ............................................IV
Machine Caution Label ................................................IV
Notes on the Stand ...................................................IV
Notes on the basket (option) ...........................................IV
Notes on the paper (media) ............................................ V
Precautions when using the curled media ................................ V
Notes on the specications and accessories ............................. V
WARNING ................................................................. VI
FEDERAL COMMUNICATIONS COMMISSION RADIO FREQUENCY
INTERFERENCE STATEMENT ................................................. VI
USE SHIELDED CABLES ..................................................... VI
Installation space ................................................... VII
Selecting a power cable ..............................................VIII
Chapter 1: Product Summary
1.1 Checking the Accessories ........................................... 1-2
Accessories ...............................................................1-2
Dedicated accessories ......................................................1-3
1.2 Nomenclature ......................................................1- 4
Front view : CE7000-40 .......................................................1- 4
Rear view : CE7000-40 .......................................................1-5
Front view : CE7000-60 .......................................................1-6
Rear view : CE7000-60 ....................................................... 1-7
Front view : CE7000-130/160 ................................................... 1-8
Rear view : CE7000-130/160 ...................................................1-9
1.3 Assembling ....................................................... 1-10
Mounting the Roll-medium tray ................................................1-10
Mounting the stock shafts ....................................................1-11
1.4 Connecting to the Computer ........................................ 1-13
Chapter 2: Preparing to Cut
2.1 Preparation of Cutter Plunger .........................................2-2
Cutter plunger nomenclature ...................................................2-2