2-2
2.1
Preparation of Cutter Plunger
This chapter describes the structures and types of the cutter plungers (cutter pens).
Cutter plunger nomenclature
The plotter cuts using a cutter blade mounted in a plunger. There are two different plungers to suit the diameter
of the cutter blade to be mounted (the φ0.9 mm cutter plunger is provided as a standard accessory). Be sure to
mount the cutter blade in the corresponding cutter plunger.
CAUTION
To avoid bodily injury, handle cutter blades with
care.
PHP33-CB09N-HS/PHP33-CB15N-HS
Cutter blade Plunger
Blade-length adjustment knob
Plunger-cap
(Blue: For φ0.9 mm-diameter blades)
(Red: For φ1.5 mm-diameter blades)
To Next Page
Loading...
