GRAPHTEC CE7000 Series - 1.4 Connecting to the Computer

1-13
1.4
Connecting to the Computer
Connect the plotter to the computer using the interface cable. Use one of the USB ports, the network (LAN)
interface or the RS-232C port to connect the plotter to the computer. Select the port depending on the specication
of the software to be used and the availability of the interface port on the computer.
Please install driver software before connecting.
Depending on the port used, use one of the USB cable (standard accessories), the network (LAN) cable
(commercially available product) or the RS-232C cable (commercially available product) to connect. Use the
cables specied by Graphtec, matching the computer that is to be connected.
* RS-232C interface depends on the sales area. For details, please contact the distributor where you purchased.
Connection
1
Check that the power switch is turned off (the " " side is
pressed down).
CE7000-130/160CE7000-40/60
Supplement
See the "Setting Interface" for setting the
interface.
2
Connect the plotter to the computer using the interface cable.
* This section explains in the CE7000-130.
USB cable
(accessories)
Computer
Connection via USB interface