GRAPHTEC CE7000 Series - Assignmnent

2-28
Assignmnent
The hold-down force of push rollers on both ends (left/right) should set to the same force in Strong or Medium.
Howevver, when using three or more push rollers, set the hold-down force of the push rollers inside both ends to
lower than both ends.
When using two push rollers
GOOD
NG
When right and left
hold-down forces are
different
Strong
Strong Strong
Strong Medium
Medium Medium Low Low Low Low
Medium
When using four push rollers
GOOD
NG
When three hold-down
forces are different
All other than above
Strong StrongMedium
Medium
Medium Medium Medium Medium Medium
MediumLow Low