2-51
Setting the acceleration
Set the acceleration of the tool that is used in each of the tool condition numbers.
Setting range : CE7000-40 : 1 to 3
: CE7000-60 : 1 to 3
: CE7000-130 : 1 to 2
: CE7000-160 : 1 to 2
Operation
Supplement
Perform the settings in Normal mode.
1
Press the [COND/TEST] key in the default screen.
CONDITION setting screen (1/3) is displayed.
2
Press the POSITION ( ) key.
CONDITION setting screen (2/3) is displayed.
Supplement
It will return to CONDITION setting screen (2/3)
without changing the settings when you press
the [ESC] key (CANCEL).
3
Press the [1] key (ACCELERATION).
ACCELERATION setting screen is displayed.
* Display may vary depending on the selected tool condition number.
4
Press the POSITION (
) keys and select the tool condition
number (CONDITION No.).
5
Press the POSITION ( ) keys and increase or decrease the
setting value.
To Next Page
Loading...
