2-63
2.12
About Simple mode
Simple settings can be made from the menu in Simple mode.
Five different tool conditions can be switched on for different media. Copying can also be done from Simple mode.
Simple mode and Normal mode are independent from each other. When a different mode is activated, the new
mode's settings will take precedence.
In [Simple mode / Normal mode] on the ADVANCE (ADV.) menu, switch between Simple mode and Normal mode.
When switching the mode, it will start from the MEDIA SELECT screen.
Supplement
•
In Simple mode, network (LAN) interface and RS-232C interface are not available.
•
In Simple mode, ARMS settings cannot be used. Even in Simple Mode (performing operations) commands for specifying the
registration marks can be used. For items with no specied commands, the specied ARMS settings in Normal mode will be used.
You can choose the following settings on Simple mode's default screen.
See "How to Use Control Panel" for detailed information.
READY screen
(Simple mode)
[COND/TEST] : Set [Tool Conditions]. (See : Selecting Tool Condition)
[COPY] : Make a copy. (See : Copy)
You can choose the following settings on the Simple mode menu screen.
MENU screen
(Simple mode)
[1] (MEDIA) : Set Page Length.
[2] (I/F) : Set “HP-GL ORIGIN POINT” and “GP-GL STEP SIZE”.
[3] (ADV.) : Set Language and Length Unit.
That concludes the Simple mode menu screen setting explanation.
To Next Page
Loading...
