2-62
Supplement
"T" is the target value of the blade length, and
"H" is the current blade height (amount).
Turning the blade-length adjustment knob
displays the number of turns and direction.
12
Press the [2] key (CHECK).
The height is calculated by moving the tool up and down.
The amount and direction to turn the adjustment knob is displayed.
CAUTION
Depending on the loaded media, the blade
might sink in to the media, making accurate
measurement impossible.
13
Turn the blade-length adjustment knob and adjust the cutter
blade length.
Current blade length is displayed by pressing the [2] key
(CHECK) , so adjust the blade length until it matches the
thickness of the media.
14
Press the [ESC] key (END).
Adjustment is completed and it will return to CONDITION setting screen
(3/3).
15
Press the [COND/TEST] key.
I will be return to default screen. After completing the settings, press
[ENTER] key.
To Next Page
Loading...
