GRAPHTEC CE7000 Series - Page 93

2-61
Supplement
See "Structure of Cutter Plunger" for blade
length adjustment knob.
6
As instructed, turn the blade length adjustment knob to the
left to fully retract the blade.
Blade
Supplement
Adjustment is only possible for the cutter pen
set in Tool Holder (Backward). It does not apply
to Tool Holder (Forward) . See "Attaching a Tool"
for instructions on setting.
7
Set the cutter plunger in Tool Holder (Backward).
8
Press the [ENTER] key.
The height is calculated by moving the tool up and down.
TO ACHIEVE THE TARFET LENGTH screen is displayed.
9
Press the [1] key (BLADE LENGTH TARGET).
BLADE LENGTH TARGET screen (TARGET) is displayed.
10
Press the POSITION ( ) keys and increase or decrease the
setting value.
11
Conrm the settings and press the ENTER key (SET).
The Blade Length Target will be selected, and it will return to the TO
ACHIEVE THE TARGET LENGTH screen.