GRAPHTEC CE7000 Series - Changing Mode

2-64
Changing Mode
Operation
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
Simple modeNormal mode
2
In Normal mode, press the ( ) key (ADV.) and then press the
POSITION ( ) key twice on the ADVANCE (ADV.) screen.
In Simple mode, press the [3] key (ADV.).
ADVANCE screen is displayed.
Simple modeNormal mode
3
Press the [2] key (SIMPLE MODE) in the Normal mode, or
press the [3] key (NORMAL MODE) in the Simple mode.
USER switch selecting screen is displayed.
4
The [1] key (Yes) allows you to change the mode after
resetting the CE7000.
The [ESC] key (No) allows you to return to the previous
screen without changing the mode.
5
When the user is switched, the cutting plotter will be reset.